Seagate ST31230N/ND Guia de Instalação descarregar pdf (Página 94)

8-22 Cabling, installing, and configuring the peripheral devices

Configuring local and remote modems

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

modem’s default speed when resetting or powering up. For

modem 9600 bps access, set the terminal to 9600 bps. For

2400 bps access, set the terminal to 2400 bps.

Setting up a U.S.

Robotics modem for

configuration as a

local modem

You must set up the DIP switches on the U.S. Robotics 33.6

or 14.4 modem to their initial setting, then configure it

through commands from a connected terminal using a

straight-through RS-232 cable, set the DIP switches to their

final setting. To set up a local modem that will be connected

to the A/B switch, power off the modem and set the DIP

switches to their initial setting (shown in boldface) as

follows.

Note: Down is ON for these switch settings.

Switch

position Action Setting

1 DTR normal

DTR override

Down

Verbal results code

Numeric results code

Down

3 Suppress results code

Display results code

Down

Echo offline commands

No echo, offline commands

Down

Auto answer on first ring or higher

if specified in NVRAM

Suppress auto answer

Down

Carrier Detect normal

Carrier Detect override

Down

7 Load NVRAM defaults

Load factory defaults

Down

8 Dumb mode

Smart mode

Down

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 271 272

Comentários a estes Manuais

Sem comentários

Seagate ST31230N/ND Guia de Instalação Página 94

Comentários a estes Manuais