Seagate ST31230N/ND Guia de Instalação descarregar pdf (Página 137)

Configuring the Meridian 1 Option 11 switch 10-3

Entering overlays

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

Entering overlays

Preparation

Check the configuration of the software and hardware on the

Meridian 1 Option 11 switch before installing Meridian Mail.

See Chapter 11 of this manual, “Install the EC 11 to Meridian

1 Option 11 switch interface.”

Have the following documentation on hand:

• X11 Input/Output Guide NTP 553-3001-400

• Circuit Pack Option Settings NTP 553-2201-211

• Circuit Pack Installation and Testing NTP 553-3001-211

Skillset required

In order to complete the procedures in this section, it is

assumed that you are a technician who is both skilled and

experienced in the operation of the Option 11 switch.

Terminal operation

Log on to the Meridian 1 before you load any of the overlays.

Load the overlay with the command LD nn, where nn is the

number of the overlay (example LD 22).

In the tables showing your responses to prompts from

Meridian 1 overlays, respond only to the prompts that are

shown. If you see a prompt on the terminal that is not in the

table, press <cr> until you see the next prompt that is in the

table.

After the last prompt shown in the table, press <cr> until the

first prompt (usually REQ) appears again before exiting the

overlay. If you do not do so, the information you entered will

be discarded when you exit the overlay.

When the first prompt (usually REQ) appears again, enter

**** or END, followed by <cr>, to exit an overlay.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 271 272

Sem comentários

Seagate ST31230N/ND Guia de Instalação Página 137