Seagate ST3400071FC Guia do Utilizador descarregar pdf (Página 124)

100

101

10.18

Command Line Interface Reference InForm OS Version 2.2.4

■ The controlport rcip addr command is only allowed for node/slot/port combinations

where there is an interface installed.

EXAMPLES

The following example shows how to reset port 1 in slot 0 on node 0 to target mode:

The following example shows how to increase MTU to 9000 on Gigabit Ethernet port 1 in node

6, slot 3:

The following example shows how to set Remote Copy interface

172.16.1.11 on a Gigabit

Ethernet port 1 in node 6, slot 3 using a netmask of

255.255.255.0:

The following example shows how to set the gateway for Gigabit Ethernet port 1 in node 6,

slot 3 using a gateway address of

172.16.1.1:

NOTES

■ If the controlport rst or controlport offline commands are issued for ports that

have active hosts or physical disks, a warning is displayed and you are prompted for

confirmation to continue with the command.

■ If the ct, cl2, rate, or persona subcommands are specified on the command line, the

port automatically resets for the changes to take effect.

■ Issue the showport command with either the –i or –par options to verify the success of

the

controlport command. See showport on page 22.96.

cli% controlport rst –m target 0:0:1

cli%

controlport rcip mtu 9000 6:3:1

Remote Copy change successful.

cli% controlport rcip addr 172.16.1.11 255.255.255.0 6:3:1

Are you sure you want to change the address for 6:3:1?

select q=quit y=yes n=no: y

Remote Copy interface change successful.

cli% controlport rcip gw 172.16.1.1 6:3:1

Are you sure you want to change the gateway for 6:3:1?

select q=quit y=yes n=no: y

Remote Copy interface change successful.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 717 718

Comentários a estes Manuais

Sem comentários

Seagate ST3400071FC Guia do Utilizador Página 124

Comentários a estes Manuais

Manuais e produtos relacionados com Software Seagate ST3400071FC