Seagate ST39103LC Guia do Utilizador descarregar pdf (Página 19)

Chapter 2. SVA Path Hardware Setup 9

Hardware Preparation

Configuring an HP

System to See New

Devices

Perform the following steps on the HP host:

Note: If any of the following steps do not produce the

expected result, refer to your HP-UX system administrator

documentation for instructions on setting up the host

platform correctly.

1. For Fibre channel connection, contact your Custome Service

Engineer to set domain addresses in the SVA 9500. For

SCSI, manually set the domain addresses on the SVA’s

XSAs to the required configuration and reboot the XSAs.

2. Log in as

root.

3. Open a console or terminal window.

4. Run

ioscan and verify that the new storage resource is

recognized by the system:

# ioscan -fn

5. Each of the three disk devices in our example is seen twice,

once on the first controller (

c1) and again on the second

controller (c2).

Verify that all of the new device(s) you have defined are

included in the display. They are identified with a type of

STK-9200-nnnn.

Write down the first six characters (the controller, target, and

device numbers) of the new device(s). This information

looks something like:

c1t0d0

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Sem comentários

Seagate ST39103LC Guia do Utilizador Página 19