Seagate ST11200N Informações Técnicas descarregar pdf (Página 45)

Configuring Robotic Controls

▼ To ensure the driver device files are accessible after a system boot

❖ Add the following command to the system startup script:

/usr/openv/volmgr/bin/driver/mkdev_ovpass

▼ To remove the ovpass driver

❖ Enter: /usr/openv/volmgr/bin/driver/remove_ovpass

Upgrading The SCSI Passthru Driver

Note The following upgrade procedure is required only if you get an error while trying to

configure a FCP SCSI device. See step 5 on page 33 for details.

Some versions of Media Manager before release 4.5 used a version of the passthru driver

that did not support FCP SCSI controllers.

Caution Any device files (/dev/ovpassn) will be removed and must be re-created.

▼ To upgrade to the latest passthru driver

1. Remove the old ovpass driver.

/usr/openv/volmgr/bin/driver/remove_ovpass

2. Install the new ovpass driver.

/usr/openv/volmgr/bin/driver/install_ovpass

Configuring Robotic Controls

Robots are controlled through a SCSI or a network connection.

◆ SCSI control is covered in the following section.

◆ Configuration for network controlled robotic libraries (for example, ACS robots) is

discussed in the appendices of the VERITAS NetBackup Media Manager System

Administrator’s Guide for UNIX and Linux or the VERITAS NetBackup Media Manager

System Administrator’s Guide for Windows.

Chapter 3, IBM AIX 31

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 112 113

Sem comentários

Seagate ST11200N Informações Técnicas Página 45