Seagate ST118273WC Guia do Utilizador descarregar pdf (Página 69)

HP-UX version 11.00.01 6-1

Configuring CD-ROM Drives 6-

NOTE

Continuum Series 400 systems support CD-ROM drives in a slightly

different manner than Hewlett-Packard systems, due to support on the

external SCSI bus only. However, Continuum Series 600 and 1200 systems

support CD-ROM drives in the same manner as Hewlett-Packard systems.

If you are aware of the Hewlett-Packard system model for CD-ROM

support, you should be aware of these differences before replacing or

installing a new CD-ROM drive. You cannot use the internal SCSI bus to

support CD-ROM drives on a Continuum system.

Continuum Series 400 systems support both 4X and 15X types of CD-ROM drives.

Continuum Series 600 and 1200 systems support only 15X types of CD-ROM drives.

Despite their differences, any of these drives can be configured into the HP-UX

operating system by the same basic procedure:

1. Set the CD-ROM drive to a unique address on the SCSI interface bus.

2. Add the device to the system and run the addhardware command.

3. Follow the steps documented in this chapter to configure the HP-UX operating

system for the device.

When configuring a CD-ROM drive, refer to the appropriate hardware installation

guides for your system, the HP-UX Operating System: Fault Tolerant System

Administration (R1004H), and the online man pages, as needed.

NOTE

You can configure CD-ROM drives either though SAM or the

command-line interface.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 85 86

Sem comentários

Seagate ST118273WC Guia do Utilizador Página 69