Seagate ST118273WC Guia do Utilizador descarregar pdf (Página 41)

HP-UX version 11.00.01 3-1

Configuring Serial Ports for Terminals

and Modems 3-

This chapter contains the procedures for configuring serial ports and related

terminals and modems on a Continuum system. For the HP-UX operating system to

communicate with a terminal or modem, the following conditions must be met:

■ The serial device driver that is required to communicate with the device must be

configured into the kernel.

■ The terminal or modem must be attached and configured to the port.

■ A device special file must be created to communicate through the port.

■ A getty process must be run against the (terminal) port to solicit logins.

Configuring Console Controller Serial Ports

Stratus provides a default configuration for the ports supported by the console

controller. (See the “Getting Started” chapter in the HP-UX Operating System: Fault

Tolerant System Administration (R1004H) for a description of console controller

features.) However, you might need to change the configuration at some point. This

section describes how to properly configure the console port(s) and terminal to

communicate with your system.

See Chapter 7, “Configuring Asynchronous Serial Interfaces,” for information about

configuring asynchronous serial ports off other cards. See the “Remote Service

Network” chapter in the HP-UX Operating System: Fault Tolerant System

Administration (R1004H) for information about configuring the Remote Service

Network (RSN).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

Sem comentários

Seagate ST118273WC Guia do Utilizador Página 41