Seagate ST1.2 Series Especificações descarregar pdf (Página 7)

ST1

M/ST1

Controller Installation Guide, Rev. E

1.1 Set the Controller BIOS Address

Controllers and add-in boards are installed in the bus slots on the

computer’s motherboard. These slots are recognized by the computer

BIOS address number. Each board installed must be

jumpered

for a

specific address.

C8000H

is the default BIOS address for the ST1

1M/ST11

If this

address is already occupied by another board, use the jumpers provided

to change the

Seagate

controller to another address. Refer to Figure 3.

When installing a ST1 1

M/ST1

controller with a

Seagate

ST01/ST02

SCSI Host Adapter, the controller must be at the lowest address

(C8000H).

When installing the ST1 1

M/ST1

in a system already containing a hard

disc controller, the

Seagate

controller must be

jumpered

at a higher BIOS

address than the resident controller. If you are not sure of the other

controller’s address, try one of the higher addresses for the

Seagate

controller.

Controller physical installation will only involve setting the BIOS address

(Figure

3),

attaching the cables and inserting the controller in a system

bus slot (Figure 4). It is often easier to attach the cables before you install

the controller.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentários a estes Manuais

Sem comentários

Seagate ST1.2 Series Especificações Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com não Seagate ST1.2 Series