Seagate ST12550WD Guia do Utilizador descarregar pdf (Página 25)

KZPSA PCI-to-SCSI Storage Adapter

4–2 EK–KZPSA–UG. B01

If there is an error, try system power-on again. If the KZPSA error persists, refer

to Chapter 7, Troubleshooting.

NOTE

If the KZPSA passes self-test, no message is dis-

played at console boot.

Enter "show config" at the console prompt to see if the devices on the

KZPSA SCSI bus can be accessed. This command displays the system configu-

ration as determined by the SRM console during power-up (Refer to your AXP

Systems Documentation.) This display should identify the KZPSA adapter and

an indented list of attached devices.

4.3 KZPSA Adapter Configuration

There are three parameters that you can and may want to change before booting

the operating system. For more information about the parameters, read Chapter

2, Planning your System Configuration. Each of these parameters are changed

using the set command. The parameters are:

• KZPSA SCSI ID

• SCSI Termination Power

• SCSI Fast Data Transfer

If the defaults are OK, and you don’t want to use a KZPSA device as a boot de-

vice, you’re done! Boot the system and enjoy. If you want to configure a KZPSA

device as a boot device, go to the last section of this chapter (KZPSA Device

Booting).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 66 67

Sem comentários

Seagate ST12550WD Guia do Utilizador Página 25