Seagate ST32430N Especificações descarregar pdf (Página 98)

Hard Disk Drive Tray – HDDT I/O Board Replacement

96 Application ModuleX Service 12/01

Honeywell

HDDT I/O Board

Removal/

Replacement

Procedure

Table 5-3 HDDT I/O Board Replacement Procedure

Step Action

Turn off power using the switch on the node power supply.

Disconnect the item connected to J1 on the HDDT I/ O board. This is the SCSI interface

cable to the optional DAT/CD-ROM devices if they exist. It is a terminator assembly if the

optional devices do not exist.

Remove the board by removing the two screws that secure the face plate to the chassis.

Non-CE Compliant HDDT I/O boards have extraction/insertion levers instead of screws.

Insert the replacement board. Make sure it is properly seated.

Reconnect the cable (or terminator assembly) onto J1 of the new HDDT I/O board. This

item was removed in step 2.

The node is ready for power on and loading. Turn on the power switch located on the A

node power supply.

Perform the node loading procedures. Reference: >> A

M System Administration manual

(Section 3).

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 153 154

Sem comentários

Seagate ST32430N Especificações Página 98