Seagate ST9100AG Guia de Instalação Página 1

. . . . . . . . . . . . . . . . . . . . . . . . . .ST9100A. . . . . . . . . . . . . . . . . . . . . . . . . . ST9100AG. . . . . . . . . . . . . . . .

some drive diagnostic programs may fail, typically resulting intime-out errors. Consult your system documentation or call yoursystem dealer or manufac

drive partitions. This process verifies the information written bythe low-level format and creates file allocation tables (used tocatalog and access f

• Check all cards. Make sure all cards are secured in theexpansion slots on the motherboard. Full size (16-bit) cardscannot be plugged into half-size

Appendix A.AT interface connector pin assignmentsReset–GroundDD7DD8DD6DD9DD5DD10DD4DD11DD3DD12DD2DD13DD1DD14DD0DD15Ground(removed)DMARQGroundDIOW–Grou

Appendix B. Mounting dimensions4X 3 mm × 0.5 mm,0.15 in (3.81mm)min. full thread0.0002.430 ± 0.010(61.72 ± 0.25)0.0001.227 ± 0.025(31.17 ± 0.61)3.986

Appendix C.Technical support servicesProduct technical support is available for all Seagate products bycalling the SeaFAX, SeaFONE, SeaTDD and SeaBOAR

• Reprints of Seagate documentation.• A directory of information and helpful utility programs thatyou can download to your own computer.• The FINDTYPE

ContentsRead before you begin... . . . . . . . . . . . . . . 1Installation overview . . . . . . . . . . . . . . . . .

Seagate Technology, Inc.920 Disc Drive, Scotts Valley, CA 95066, USAPublication Number: 36217-001, Rev. A, Printed in USA

Read before you begin...Note. ST9100A and ST9100AG are usually installed in note-book or laptop systems. Special training or tools may beneeded to se

handle the drive carefully. In addition, do not attach any labels tothe drive top cover, as they may prevent proper ventilation.Warranty. Contact your

Setting master/slave jumpersTwo drives may be controlled through a single drive controllercable with two connectors. In this case, one drive is design

Master/slaveconfiguration jumpersPin 1Pin 20 removedfor keyingCircuit boardA CB DDrive is master, no slave drive presentDrive is master; S

Mounting the driveYou may mount (and operate) the ST9100A and ST9100AG inany orientation. However, you must securely attach the drive toa rigid frame

cal Support services (on the SeaBOARD BBS) as described inAppendix C.The methods used to configure system BIOS vary from systemto system. In many case

In a few situations, none of the drive types specified in your BIOSsetup program will match your drive, and the setup program willnot provide an oppor